Garmin GPSMAP 3210 Installation Instructions - Page 2

To install the bail-mount bracket ➊: 1. Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least 2 in. (5.1 cm) of clearance behind the GPSMAP 3000 series chartplotter for the wiring. NOTE: Mount a GPSMAP 3005C/3205C chartplotter 10 in. (25 cm), a GPSMAP 3006/3206C chartplotter 12 in. (30 cm), and a GPSMAP 3010C/3210C chartplotter 24 in. (60 cm) from a magnetic compass to avoid interference. 2. Using an appropriately sized drill bit, drill the pilot holes for your mounting hardware. 3. Secure the bail mount to the surface with your mounting hardware. To install the GPSMAP 3000 series chartplotter on the bail-mount bracket ➋: 1. Loosely attach the mounting knobs to the GPSMAP 3000 series chartplotter. 2. Slide the chartplotter onto the bail mount, and tighten the mounting knobs. Mounting knobs ➊ ➋ RANGE PAGE QUIT ENTER MARK ADJ MENU DATA CNFG FCTN NAV MOB FIND ABC DEF 1 2 3 GHI JKL MNO 4 5 6 PQRS TUV WXYZ 7 8 9 +0 - Bail mount Flush Mounting the GPSMAP 3000 Series Chartplotter Use the included flush-mount template and hardware to flush mount your GPSMAP 3000 series chartplotter. Note: Make sure the surface on which you mount the chartplotter has at least 2 in. (5.1 cm) of open space behind it to fit the chartplotter and the connected wires. NOTE: Mount a GPSMAP 3005C/3205C chartplotter 10 in. (25 cm), a GPSMAP 3006/3206C chartplotter 12 in. (30 cm), and a GPSMAP 3010C/3210C chartplotter 24 in. (60 cm) from a magnetic compass to avoid interference. Hardware (included): • Flush-mount template Tools required (not included): • Jigsaw • Four threaded mounting studs • Masking tape • Four flat washers • Scissors • Eight hex nuts • Drill • Drill bits-1/8" (3 mm) and 3/8" (6 mm) • 1/16 in. (2 mm) Allen (Hex) wrench • 4 mm socket or wrench • Marker • Center punch and hammer To flush mount a GPSMAP 3000 series chartplotter: 1. The flush-mount template is included in the product box. Trim the template and ensure it will fit in the location at which you want to flush mount the chartplotter. 2. Trim the flush-mount template and tape it to the location at which you want to mount the chartplotter. 3. Using a 3/8 in. (10 mm) drill bit, drill one or more of the four pilot holes inside the corner of the template to begin cutting the mounting surface.  GPSMAP 3000 Series Installation Instructions