Garmin GRC 10 Remote Control GRC 10 User’s Guide - Page 4

Battery Installation The GRC 10 requires two AA batteries (included). Remove the battery lid, located in the back of the unit, by pressing down and pulling out the tab. Alkaline batteries are recommended, but NiCd or NiMH batteries may be used. Stored data is not lost when batteries are removed. Install the batteries, observing the polarity diagram printed on the label inside the battery compartment. If the unit does not turn on, or the battery level show no bars, replace the batteries. Battery Cover Caution: When replacing batteries, use only new or fully charged batteries. Do not mix new and old batteries as this can cause battery leakage and damage to the unit. Do not mix battery types. CAUTION: Remove batteries if the unit will not be in use for several months. Storing batteries in the unit for prolonged periods may result in leakage and damage to the battery compartment. WARNING: Follow the manufacturer's instructions for proper care and disposal of batteries. Do not incinerate used batteries, as internal materials may ignite with explosive violence. WARNING: Do not use lithium batteries in the GRC 10.