Garmin GSC 10 Instructions (Multilingual) - Page 3

Installing the GSC 10 ‹ warning See the Important Safety and Product Information guide in the Forerunner® or the Edge® product box for product warnings and other important information. Both magnets must be aligned with their respective indication lines. 1. Place the GSC 10 on the rear chain stay (on the side opposite the drive train). NOTE: Place the flat rubber pad or the triangle-shaped rubber pad between the GSC 10 and the chain stay for stability. Reset button Indication line Cable ties GSC 10 on Rear Chain Stay 2. Loosely attach the GSC 10 using two cable ties. 3. Attach the pedal magnet to the crank arm using the adhesive mount and a cable tie. The pedal magnet must be within 5 mm of the GSC 10. The indication line on the pedal magnet must line up with the indication line on the GSC 10. Cable tie Indication line Pedal Magnet on Crank Arm 4. Unscrew the spoke magnet from the plastic piece. 5. Place the spoke in the groove of the plastic piece and tighten slightly. The spoke magnet can face away from the GSC 10 if there is not enough room between the sensor arm and the spoke. The spoke magnet must line up with the indication line on the sensor arm. EN-