Garmin GSC 10 Instructions (Multilingual) - Page 4
Pair the Sensors, GSC 10 Battery, WARNING
![]() |
UPC - 753759050030
View all Garmin GSC 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Spoke magnet GSC 10 a reset. Press Reset again if you require additional passes. 10. When everything is aligned and working correctly, tighten the cable ties, the sensor arm, and the spoke magnet. Pedal magnet Sensor arm indication line GSC 10 and Magnet Alignment 6. Loosen the screw on the sensor arm. 7. Move the sensor arm to within 5 mm of the spoke magnet. You can also tilt the GSC 10 closer to either magnet for improved alignment. 8. Press the Reset button on the GSC 10. The LED turns red, then green. 9. Pedal to test the sensor alignment. The red LED blinks each time the pedal magnet passes the sensor. The green LED blinks each time the spoke magnet passes the sensor arm. NOTE: The LED blinks for the first 60 passes after Pair the Sensors Pairing is the connecting of ANT+™ wireless sensors, for instance your GSC 10 with an Edge. After you pair the first time, your Edge automatically recognizes your GSC 10 each time it is activated. NOTE: The pairing settings differ for each compatible Forerunner and Edge model. See your owner's manual. GSC 10 Battery ‹ warning Do not use a sharp object to remove user‑replaceable batteries. Contact your local waste disposal department to properly recycle the batteries. The GSC 10 contains a userreplaceable CR2032 battery. 1. Locate the circular battery cover on the side of the GSC 10. EN-
![](/manual_guide/products/garmin-0101064400-instructions-multilingual-8b4803b/4.png)