Garmin LVC 18 Technical Specification - Page 37
Manual, Connect, Config >, Get Configuration from GPS, Sensor Configuration., Config, Switch
UPC - 753759061241
View all Garmin LVC 18 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
4. Select the Serial Port to which the GPS 18 is connected. Select Auto to have the program automatically determine the Baud Rate, or select Manual to manually select the Baud Rate of the GPS 18. Click OK when done. 5. Click the Connect icon , or select Comm > Connect to connect to the GPS 18. 6. To view the current programming of the GPS 18, select Config > Get Configuration from GPS (or press the F8 key). The current programming of the GPS 18 is displayed in the window, as shown on the previous page. 7. Open the Sensor Configuration Window by pressing the F6 key or selecting Config > Sensor Configuration. 8. Place a check mark in the box next to "Binary Output Data" to change the GPS 18 to Garmin Mode. The unit will keep this change in the programming until you change it again in the software. Note: Selecting Config > Switch to Garmin Mode (or pressing the F11 key) only changes the unit to work in Garmin Mode until power is cycled through the unit again. For a more permanent change, refer to step 8 above. 9. Click OK. 10. When you are ready to upload the changes into the GPS 18, select Config > Send Configuration to GPS (or press the F9 key). The new configuration is then loaded into the GPS 18. 11. You may disconnect and close the software when finished. The software configuration can also be saved for future reference. Refer to Appendix E: Sensor Configuration Software for complete information about downloading the Sensor Configuration Software application. GPS 18 Technical Specifications (190-00307-00) Page 31 Rev. D