Garmin PRO 550 Plus Owners Manual - Page 8

seconds. The effectiveness of vibration may vary based on the dog's temperament and experience. Intensity Levels The Pro 550 Plus system provides 6 stimulation intensity levels, which increase sequentially from 1 to 6. Within each intensity level, you can select low, medium, and high stimulation using the training keys (Training Key Functions, page 4). Choosing the Correct Intensity Level 1 Set the intensity to the lowest level (Changing the Intensity Level, page 4). 2 Select a training key. 3 Observe the dog for a reaction, such as a head shake, neck movement, or just a change in expression. Sometimes dogs will vocalize due to the surprise of the electrical stimulation. If the dog vocalizes more than once, the intensity level is too high for beginning training. 4 If there is no reaction, increase the intensity level by one level until the dog has a slight but recognizable reaction to the stimulation. The intensity level that causes a slight but recognizable reaction is your dog's baseline level for beginning collar training. You do not need to, and should not, apply this intensity selection test again. After you begin training, the dog's performance guides your intensity selection. As the dog advances in training, you may need to change the level depending upon the training situation. Changing the Intensity Level You can select a different intensity level for each dog collar device. 1 Select a dog collar device (Selecting a Dog Collar Device, page 3). 2 Adjust the dial to increase or decrease the intensity level. Training Key Functions The Pro 550 Plus system provides several training modes, which assign different combinations of momentary stimulation, continuous stimulation, and tone to the training keys. The three vertical letters next to the mode toggle switch correspond to the training key functions, from top to bottom. Key Momentary (M) Accessory (A) Continuous (C) Tone key Tone Tone Tone Top training key Momentary stimulation or vibration (medium) Light on Continuous stimulation or vibration (medium) Bottom training key Momentary stimulation or vibration (low) Light off Continuous stimulation or vibration (low) Both training keys Momentary stimulation or vibration (high) Not Applicable Continuous stimulation or vibration (high) Locking and Unlocking the Training Keys You can lock the training keys to prevent inadvertent key presses. • To lock the keys, turn the intensity dial to N. • To unlock the keys, turn the intensity dial to any other setting. Using the Light You can use the light feature on your device to verify pairing, help locate your dog, and provide safety for your dog at night. 1 Select a dog collar device (Selecting a Dog Collar Device, page 3). 2 Move the mode toggle switch to A. 3 Select the top training key to turn the light on. 4 Select the bottom training key to turn the light off. Device Information Support and Updates • You can update software for your handheld device and mini dog collar device using Garmin Express™. • You can update software for your dog collar device using Garmin® WebUpdater (PC only). Product Updates On your computer, install Garmin Express (www.garmin.com /express). This provides easy access to these services for Garmin devices: • Software updates • Product registration Setting Up Garmin Express 1 Connect the device to your computer using a USB cable. 2 Go to garmin.com/express. 3 Follow the on-screen instructions. Updating the Dog Collar Device Software Before you can update the dog collar device software, you must connect the dog collar device to a computer (Connecting the Collar to a Computer, page 5). NOTE: PC only. Updating the software does not erase any of your data or settings. 1 Go to www.garmin.com/products/webupdater. 2 Follow the on-screen instructions. Device Care NOTICE Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause permanent damage. Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes. Secure the weather cap tightly to prevent damage to the USB port. Cleaning the Device 1 Wipe the device using a cloth dampened with a mild detergent solution. 2 Wipe it dry. After cleaning, allow the device to dry completely. Calibrating the Compass on the Handheld Device The device has a 3-axis electronic compass. You may need to calibrate the compass after using the handheld device inside a vehicle, exposing the handheld device to a magnet, or experiencing temperature changes. NOTICE Calibrate the electronic compass outdoors. To improve heading accuracy, do not stand near objects that influence magnetic fields, such as vehicles, buildings, and overhead power lines. 4 Device Information