Garmin Xero A1i Bow Sight Owners Manual - Page 12

6 From the Garmin Express application, click Add a Device. The Garmin Express software detects your device. 7 Click Add Device. 8 Follow the on-screen instructions to register your device and add it to the Garmin Express software. When setup is complete, the Garmin Express software searches for software updates for your device. 9 Select an option: • To install all available updates, click Install All. • To install a single update, click View Details, and select an update. 10When the software update is complete, disconnect the device from your computer. 11Reinstall the battery door. The device installs the software update. Connecting the Device to Your Computer Before you can connect the device to your computer, you may need to remove optional mount accessories. 1 Using a 5/64 inch hex wrench, loosen the four screws securing the battery door. 2 Remove the battery door, and set it aside. NOTE: Do not remove the batteries. 3 Plug the small end of the USB cable into the USB port on the device. 4 Plug the large end of the USB cable into a computer USB port. 5 If the bow sight is turned off, press to turn on the device. The bow sight enters USB mass storage mode. Device Care NOTICE Avoid extreme shock and harsh treatment, because it can degrade the life of the product. Do not use a sharp object to clean the device. Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes. Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause permanent damage. • Go to www.garmin.com/outdoor. • Go to http://buy.garmin.com, or contact your Garmin dealer for information about optional accessories and replacement parts. Troubleshooting The point of impact moves between shots There are several factors that can cause variations in the point of impact. • Verify the screws that connect the mount to the riser are tightened to the maximum torque specification of 6.7 N-m (60 lbf-in) and the mount cannot be moved on the bow. NOTE: Do not exceed the bow manufacturer's recommended torque values. • Verify each adjustment point on the mount is tightened to the maximum torque specification of 2.2 N-m (20 lbf-in). • Verify you are using the correct arrow profile for the arrow you are using (A1i models only). • Range your shots consistently at full draw or at rest. • Inspect your bow and confirm all components are in good working condition. • Always use consistent form when shooting a bow. Variations in stance and peep sight placement can affect accuracy. My device only displays fixed pins When the batteries are low or do not meet the minimum power requirements for the laser rangefinder, the device allows only fixed pin sighting. • Verify the battery level of the batteries you have installed. • Verify you are using AAA lithium batteries. Tips for Consistent Ranging If you are a target shooter, consistent ranging can help to increase your accuracy. • Use the rangefinder consistently while you are using the same form (at full draw or at rest). • Enable decimal precision (Units Settings, page 7). • Verify you are aiming the reticle at the target when you release the ranging trigger. Resetting the Device If the device stops responding, you may need to reset it. This does not erase any of your saved data or settings. 1 Hold for 12 seconds. The device turns off. 2 Hold for one second to turn on the device. Cleaning the Device 1 Dampen a soft, clean, lint-free cloth with fresh water. 2 Gently wipe the device. Getting More Information You can find more information about this product on the Garmin website. • Go to support.garmin.com. 8 Device Information