Garmin Xero A1i Bow Sight Owners Manual - Page 7
Aligning the Rangefinder with the Primary Pin, on the rangefinder reticle.
View all Garmin Xero A1i Bow Sight manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
you will decrease visibility of closer targets. If you set your primary pin for shorter distances, you will have greater visibility of close targets, but a shorter maximum range. 2 Nock an arrow, and draw your bow. 3 Looking through your bow's peep sight at full draw, align the primary pin with the center of the target . Aligning the Rangefinder with the Primary Pin The circular rangefinder reticle indicates the direction the laser rangefinder is pointing. For best accuracy, you must align the circular rangefinder reticle with the primary pin. 1 Nock an arrow. 2 Bring the bow to full draw, and align the peep sight with the sight housing ring. 3 Observe the arrows on the rangefinder reticle. The arrows indicate the direction you must move the curved adjustments on the mount. Each arrow in the optic corresponds with one degree of adjustment on the curved rails. 4 Confirm the bubble in the level is centered between the lines. 5 Shoot at the target, and observe the point of impact. 6 Using a 7/64 inch hex wrench, loosen the vertical adjustment on the mount. 4 Using a 7/64 inch hex wrench, adjust the curved vertical and curved horizontal adjustments on the mount in the directions the arrows indicate. For example, if the arrows point up and right, move the curved mount pieces up and right. 7 Move the vertical adjustment in the direction of the arrow's point of impact. 8 Tighten the vertical adjustment to a maximum torque specification of 2.2 N-m (20 lbf-in). 9 Using a 7/64 inch hex wrench, loosen the horizontal adjustment on the mount. 10Move the horizontal adjustment in the direction of the arrow's point of impact. 11Tighten the horizontal adjustment to a maximum torque specification of 2.2 N-m (20 lbf-in). 12Continue adjusting the mount, as needed, until the point of aim and the point of impact are the same. TIP: You should adjust the mount in the direction of the point of impact. For example, if the arrow impacts low and right, you should adjust the mount down and right. You should always tighten the mount screws to a maximum torque specification of 2.2 N-m (20 lbf-in) between adjustments. TIP: Each mark on the curved adjustments indicates one degree. Garmin® recommends moving the curved rails in small increments as indicated by the arrows in the optic when making adjustments. 5 Continue adjusting the mounts until the primary pin is centered in the circle of the rangefinder reticle at full draw. Calibrating the Bow Sight 3