Garmin fleet 670V Owner s Manual - Page 5
Connecting the Device to Vehicle Power
View all Garmin fleet 670V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Getting Started WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Connecting the Device to Vehicle Power Entering and Exiting Sleep Mode You can use sleep mode to conserve battery power when your device is not in use. While in sleep mode, your device uses very little power and can wake instantly for use. TIP: You can charge your device faster by putting it in sleep mode while charging the battery. Press the power key . À WARNING This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage caused by battery exposure to extreme heat, store the device out of direct sunlight. Both the device and its mount contain magnets. Under certain circumstances, magnets may cause interference with some internal medical devices, including pacemakers and insulin pumps. Keep the device and its mount away from such medical devices. NOTICE Both the device and its mount contain magnets. Under certain circumstances, magnets may cause damage to some electronic devices, including hard drives in laptop computers. Use caution when the device or its mount is near electronic devices. Before you use your device on battery power, you should charge it. 1 Plug the vehicle power cable into the USB port on the À mount. Turning Off the Device 1 Hold the power key until a prompt appears on the screen. The prompt appears after five seconds. If you release the power key before the prompt appears, the device enters sleep mode. 2 Select Power Off. Resetting the Device You can reset your device if it stops functioning. Hold the power key for 12 seconds. Acquiring GPS Signals To navigate with your device, you must acquire satellites. in the status bar indicates the satellite signal strength. Acquiring satellites can take several minutes. 1 Turn on the device. 2 Wait while the device locates satellites. 3 If necessary, go outdoors to an open area, away from tall buildings and trees. Adjusting the Screen Brightness 1 Select Settings > Display > Brightness. 2 Use the slider bar to adjust the brightness. 2 Press the mount onto the suction cup until it snaps into Á  place. The Garmin® logo on the mount should face right-side up. 3 Press the suction cup to the windshield, and flip the lever à back toward the windshield. 4 Place the back of the device onto the magnetic mount. 5 Plug the other end of the vehicle power cable into a power outlet in your vehicle. Support and Updates Garmin Express™ provides easy access to these services for Garmin devices. Some services may not be available for your device. • Product registration • Product manuals • Software updates • Map, chart, or course updates • Vehicles, voices, and other extras Setting Up Garmin Express 1 Connect the device to your computer using a USB cable. 2 Go to www.garmin.com/express. 3 Follow the on-screen instructions. Adjusting the Volume 1 Select Volume. 2 Select an option: • Use the slider bar to adjust the volume. • Select to mute the device. • Select for additional options. Home Screen NOTE: The home screen and customization options may vary based on configuration by your fleet management company. Select to view installed apps and widgets. À Swipe left and right to switch pages. Á Hold to customize wallpaper. Swipe up to view notifications.  Getting Started 1