Garmin zumo 220 Quick Start Manual - Page 5
Mount Your zūmo on the, Motorcycle - motorcycle mount
UPC - 753759101657
View all Garmin zumo 220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Mount Your zūmo on the Motorcycle ‹ Warning Incorrectly wiring the power cable with bare wire leads can result in damage to the vehicle or the battery and can cause bodily injury. Garmin strongly recommends having an experienced installer with the proper knowledge of electrical systems install the unit. NOTE: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in. Handlebar Handlebar base U-bolt Notice To avoid draining the motorcycle battery, disconnect the power cable from your zūmo device when you are not riding. NOTE: Select a suitable and secure location to mount the zūmo on your motorcycle, based on available power sources and safe cable routing. Install the Handlebar Base The zūmo includes parts for two handlebar installation solutions. Custom mounts can require additional hardware (www.ram-mount .com). Installing the U-bolt and handlebar base: 1. Place the U-bolt around the handlebar, and thread the ends through the handlebar base. 2. Tighten the nuts to secure the base. Do not overtighten. Installing the handlebar base to the clutch/ brake clamp bracket: NOTE: Both 1/4 in. standard and M6 bolts are included. Match the size of the factory bolts on your clutch/brake clamp bracket. 1. Remove the two factory bolts on your clutch/ brake clamp bracket. 2. Thread the new bolts through the handlebar base, spacers, and clamp bracket. 3. Tighten the bolts to secure the base. Handlebar base Clutch/brake clamp bracket Spacers zūmo 220 Quick Start Manual