Gateway E-9510T Gateway 9510 Server User Guide - Page 156

Beeps 4 5 6 7 8 9 10 11 Troubleshooting Description Troubleshooting steps System board timer not operational. Possible system board malfunction. To eliminate the possibility of an add in-card problem, remove all expansion cards. n If the beep code occurs even when all expansion cards have been removed, the system board is at fault. n If the beep code does not occur when the expansion cards have been removed, one of the cards is causing the problem. Install the cards one at a time until the problem happens again. When the beep code returns, the most recent card you installed is at fault. A processor on the system board generated an error. Remove one of the processors if two are installed, the try a known good processor in the first socket. Same as for 4 beeps. The keyboard controller (8042) may be defective. The BIOS cannot switch to Protected mode. Remove the keyboard to see if the error goes away. If it does, try a known good keyboard. Same as for 4 beeps. General exception error (processor exception error). Same as for 4 beeps. Same as for 5 beeps Display memory error (system video adapter). If the system video adapter is an add-in card, replace or reseat the video adapter. If the video adapter is integrated into the system board, the board may be faulty. Try using an add-in card. The ROM checksum value does not match Same as for 4 beeps. the value encoded in the BIOS. The shutdown register for CMOS RAM failed. Same as for 4 beeps. The cache memory test failed. Same as for 4 beeps. www.gateway.com 151