Gateway GT5268E 8511625 - Gateway Computer Hardware Reference (6-Bay Micro BTX - Page 24
Replacing the memory card reader
View all Gateway GT5268E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
CHAPTER 3: Maintenance Basics www.gateway.com 6 Remove the two drive retention screws, then slide the drive forward and out of the drive bay. Drive retention screws 7 Slide the new drive into the drive bay, line up the screw holes on the drive bay with the screw holes on the drive, then replace the two drive retention screws. Drive retention screws 8 Reconnect the drive cables using your notes from Step 4. 9 Replace the front bezel by following the instructions in "Replacing the front bezel" on page 16. 10 Replace the side panel by following the instructions in "Replacing the side panel" on page 16. Replacing the memory card reader Tips & Tricks You need a Phillips screwdriver to replace the memory card reader. Important The color and shape of your replacement card reader's front cover may vary from your original card reader. 20 To replace the memory card reader: 1 Remove the side panel by following the instructions in "Removing the side panel" on page 14. 2 Remove the front bezel by following the instructions in "Removing the front bezel" on page 15. 3 If you are installing a new card reader (not replacing an old one), remove the two drive retention screws in the drive bay, then go to Step 6. For the location of the screws, see the photo in Step 6.