Gateway ML3706 Component Replacement Manual - Page 8
Replacing the Memory Module
View all Gateway ML3706 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Replacing the Memory Module Tools You need a small Phillips screwdriver to replace the memory module. Locating Components Replacing the Memory Module 4 Disconnect all peripheral devices and remove any Express cards. 5 Turn your notebook over so the bottom is facing up, then remove the battery. For more information, see "Changing Batteries" in your Reference Guide. 6 Loosen the memory bay cover screw (this screw cannot be removed). Memory bay Preventing static electricity discharge The components inside your notebook are extremely sensitive to static electricity, also known as electrostatic discharge (ESD). ESD can permanently damage electrostatic discharge-sensitive components in your notebook. Warning To avoid exposure to dangerous electrical voltages and moving parts, turn off your notebook and unplug the AC adapter, modem cable, and network cable and remove the battery before replacing a component. Before working with notebook components, follow these guidelines: • Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. • Remove components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection. • Always hold components by their edges. Avoid touching the edge connectors. Never slide components over any surface. • Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare metal part of your workbench or other grounded connection. • Touch a bare metal surface on your workbench or other grounded object. Replacing the memory module Screw 7 Lift the memory bay cover, then remove it. Be careful not to break off the tabs located on the end of the cover opposite of the screw. 8 If you are removing a module, gently press outward on the clip at each end of the memory module until the module tilts upward. Clip Clip To replace the memory module: 1 Follow the guidelines under "Preventing static electricity discharge." 2 Turn off your notebook. 3 Disconnect the AC adapter, modem cable, and network cable. Technical Support See the label on the bottom of the notebook for Customer Care Information. See your Reference Guide for important safety, regulatory, and legal information. www.gateway.com © 2007 Gateway, Inc. All rights reserved. Gateway and eMachines are trademarks or registered trademarks of Gateway, Inc. in the United States and other countries. All other brands and product names are trademarks or registered trademarks of their respective companies. 1