Gateway NV-53 Service Guide - Page 80
Replacing the touchpad board, Tools you need to complete this task:, Screws removed during this task
View all Gateway NV-53 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
CHAPTER 3: Replacing notebook components Replacing the touchpad board Tools you need to complete this task: Phillips #0 screwdriver Flat screwdriver or Non-marring plastic scribe Screws removed during this task: • 1 black M2×5 (hard drive) • 1 black M2.5×6 (optical drive) • 3 black M2.5×6 (keyboard cover) • 2 black M2.5×6 (LCD panel hinge - bottom) • 2 black M2.5×6+Nylok (LCD panel hinge - top) • 10 M2.5×6 black (palm rest - base side) • 3 M2.5×6 black (palm rest - top side) To replace the touchpad board: 1 Complete the steps in "Preparing the notebook" on page 47. 2 Remove the palm rest by performing steps 2-18 of the "Replacing the palm rest" procedure on page 68. 3 Turn the palm rest over so that its underside is facing up. 4 Open the touchpad board cable connector (a) and disconnect the cable (b). 74