GE 24702 User Guide - Page 3
Antenna placement with mounting base - via
UPC - 030878247023
View all GE 24702 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Antenna placement with mounting base: § Before the following step, please make sure that you have enough protection when you try to drill on wall to install the antenna. § Please check the signal reception and make sure you can get a good signal at the location where you are going to install the antenna. 1. Indoor wooden wall mounting installation: Step 1: Mark the fixing position with a pencil or pen (Please use the mounting base to mark the position). Step 2: Take out the attached screws, using screw driver to fix these screws through the mounting base and fix it on the wall. Step 3: Attach the antenna to the mount base, and check the signal reception. 2. Indoor concrete or RC wall mounting installation: Please note, when you use the electric drill, you should wear the eyes protection goggles, and the drill bit must be fixed, to avoid any injury. Step 1: Take a electric drill, use a drill bit to drill a 35mm deep hole. Then clean the hole. Step 2: Take out the plastic pole, using hammer to ham it into the hole that made at step1. Step 3: Take out the screws, use screw driver, screw them through the mounting base onto the plastic pole. Step 4: Attach the antenna to the mount base, and check the signal reception. 3. Indoor wall mounting installation with the Velcro: Please note, clean the surface before stick the Velcro. Step 1: Use the Velcro inside the box, and stick to the mounting base. Step 2: Make sure the antenna can get a good signal reception at the location and position you are going to attach. Step 3: Stick the mounting base with the Velcro, and make the mounting base is secure. Step 4: Attach the antenna to the mount base, and check the signal reception. 3