GE AJCH08ACC Owners Manual - Page 17
REMOVE AIR CONDITIONER FROM CASE, STORM WINDOW REQUIREMENTS, To determine the thickness, place
View all GE AJCH08ACC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions 2 STORM WINDOW REQUIREMENTS A storm window frame will not allow the air conditioner to tilt towards the outside and will keep it from draining properly. To adjust for this, attach a piece of wood to the stool. Wood 1/2″ higher than frame Stool Sill Storm window frame WOOD PIECES: WIDTH: 2″ LENGTH: Long enough to fit inside the window frame. THICKNESS: To determine the thickness, place a piece of wood on the stool to make it 1/2″ higher than the top of the storm window frame. Attach securely with nails or screws provided by the installer. 3 REMOVE AIR CONDITIONER FROM CASE A Remove the front grille. See the Care and Cleaning section. B Find the locking plate located on the front left side. C Remove the screw and the locking plate to unlock the air conditioner. F Remove all shipping pads (if present) inside the air conditioner next to the compressor. Locking plate Remove screw D Remove and discard the shipping screw on the back of the air conditioner to allow removal of the air conditioner from the case. Remove shipping pads (if present) G Remove the rear grille that is taped to the back of the case. Remove the packet of screws taped to the back of the grille. While holding the grille at a 45° angle, insert it into the clips at the top of the case and push the bottom in. Keep slight upward pressure on the grille until it fits flush with the bottom of the case. If attaching the grille from the outside of the case use the 2 long screws. If attaching the grille on the inside of the case use the 2 short screws. Clips Remove screw E Pull the bottom corners of the air conditioner and slide it out of the case. Insert the 2 long screws on the outside Insert the 2 short screws on the inside 17