GE AJCQ10DCG Use and Care Manual - Page 16
Prepare Opening In Wall, Support Requirements For Air
View all GE AJCQ10DCG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Instructions ,167$//,1*7+528*+7+(:$// Read these instructions completely and carefully. 1 PREPARE OPENING IN WALL Make certain a wall receptacle is available close to the hole location or make arrangements to install a receptacle. The cord length for the 115-volt models is 72s to the right and 47s to the left. For the 230/208-volt models the cord length is 65s to the right and 39sto the left. MINIMUM ),1,6+(' OPENING ',0(16,216 &$6(',0(16,216 +HLJKW :LGWK +HLJKW :LGWK 'HSWK 153ø4s 261ø8s 155ø8s 261ø16s 16s *Dimensions may need to be increased to fit unique situations in the field if using case angles. 3 SUPPORT REQUIREMENTS FOR AIR &21',7,21(5 Mortar between the case and the brick wall around the case may be undercut at about 45° for improved caulking. Inside Top of case Caulking Outside Undercut mortar 2 SUPPORT REQUIREMENTS FOR AIR &21',7,21(5 The air conditioner wall case may be installed with 1/4s min. extension out from the inside wall or with 1/4s min. extension out from the outside wall. The finished sides of the opening should be structural wall members. /LQWHO² Use a lintel in brick veneer and brick and block types of wall to support the bricks or blocks above the opening. Do not allow the wall case to be used in lieu of a lintel. )ODVKLQJ² Install flashing (drip rail) as shown to prevent water from dripping inside the wall and down the outside of the building. Brick veneer Lintel angle (if required) Caulking (on all 4 sides on the outside and inside of the case) Plaster line Caulking (above and below the flashing) Trim molding (if desired) Room side Flashing (drip rail) 1/4s min. extension inside the wall from the trim molding 16