GE AZ61H12DAB Owners Manual - Page 5

Auxiliary controls on your Zoneline. Auxiliary Controls--Aux Set Button The auxiliary set controls are located behind the room cabinet, below the control panel. Removethe room cabinet. See the To Remove the Room Cabinet section. The owner is responsible for ensuring the auxiliary controls are set to the desired function. There are 9 different modes that can be set using the auxiliary set button. To change modes, press AU,_SET('AU" appears on the display).Pressthe mode button on the control pad until the first digit in the display shows the number corresponding to the mode you are choosing and the correct HEAT/COOLLEDis lit. Pressthe up or down arrow (shown in the second digit of the display)to make the mode setting selection where applicable. Pressthe AUXSET button to confirm the selection. [ MODE 1 Smart Fan--Cooling/Heating The default setting for Mode I is as follows: Cooling:Continuous (ON) Heating: Cycle (OFF) PressMODE until a 1 appears in the first digit of the display for Stoat1:Fan cool mode. The COOLLED light on the main control will be on.To change to heat mode, press MODE again. The HEATLEDlight on the main control will be lit. Pressthe down arrow to set the indoor fan to cycle on/off when the unit is heating or cooling "u." Pressthe up arrow to set the indoor fan to run continuously "n." This is shown in the second digit of the display. PressAUX SETto confirm your selection and exit AUXSET mode, or press MODE to continue setting other functions. [ MODE 2 Load Shedding (Central Desk Control) The default setting for Mode 2 is OFF. This feature is active only if the unit is connected to a CDCand the CDChas control. PressMODE until a 2 appears in the first digit of the display for Load Shedding mode. Pressthe down arrow for OFF"u" or the up arrow for ON" n." This is shown in the second digit of the display.When this mode is on, only the indoor fan can be turned ON or OFFwith the unit controls. When this mode isoff, all operation is disabled except Heat/FreezeSentinel (Mode3).PressAUXSETto confirm your selection and exit AUXSETmode, or press MODEto continue setting other functions. GEApUion e . o AuxiliarySet Button Cover R irst Digit Press "Mode" I Smart Fan t .....c.ool L_ Second Digit Press _ / W U -Cycb / b_ _ Continue B LSohaeddding hwl L,t - Off / - On Sentinel HSA1 coo_ Y COOL HEAT t Constant Fan _ J O: 60F_85F 1: 64F-85F O: 60F_65F 1: 60FWOF TLiemmitpera_tu.Are_C004 CMloadses 2 t_'_ Duct Mode ! _I 23:: 6667FF--8855FF 23: 660OFF-W724FF 45:: 7702FF--8855FF 6: 74F-85F 7: 76F-85F 45:: 6600FF°W786FF 6: 60F_80F 7: 60F_85F B A(All z162_ROMnolyde) Boost Heat (AZ61 Orlmy) Lt - off / B'_ - On # -- HIGH LJ -- LOW --AUTO Cooling- Cycle I COOL --FAN --HEAT t P'_ -- HIGH -- LOW --AUTO Cooling- Continuous ICOOL -- FAN --HEAT t -- HIGH LJ -- LOW --AUTO Heating- Cycle --COOL --FAN _HEAT lh"_ --HIGH -- LOW -- AUTO Heating- Continuous --COOL -- FAN I HEAT _7 Eu Load Shedding OFF _in E Load Shedding ON 5