GE DSXH43GFWW Owners Manual - Page 15

Installation Instructions MOBILE HOME INSTALLATION 1. Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4″ (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 2. If the dryer is exhausted through the floor, the exhaust system MUST NOT terminate beneath the mobile home. Termination MUST be securely fastened to the mobile home structure. 3. When installing a gas dryer into a mobile home, a provision must be made for outside make-up air. This provision is to be not less than twice the area of the dryer exhaust outlet. 4. Gas dryers MUST be fastened to the floor using Mobile Home Installation Kit Pub. No. 14-D346-33. 5. See the Exhaust System Checklist section for other important venting information. 6. Installation MUST conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or, when such standard is not applicable, with American National Standard for Mobile Homes, ANSI/NFPA No. 501B. In Canada, the CSA Z240 is applicable. Correct Do ROUGH-IN DIMENSIONS 26 7/8″ (68.3 cm) Electrical connection 13 9/16″ (34.5 cm) 2 9/16″ (6.5 cm) Under counter 34 5/8″ (87.9 cm) 36″ (91.5 cm) 3 3/4″ (9.5 cm) 3/16″ (0.48 cm) Dia. gas pipe 1″ (2.54 cm) REAR VIEW 3/4″ (1.9 cm) Door open 90˚ 47 1/2″ (120.7 cm) Incorrect Don't Don't Don't The dryer is designed under ANSI Z 21.5.1. 4 3/8″ (11.1 cm) Optional vent knockout 25 3/4″ (65.4 cm) SIDE VIEW 3 3/4″ (9.5 cm) SERVICING - Consideration must be given to provide adequate clearances for installation and servicing. 15