GE GE06P06SAG Use and Care Manual - Page 10

Operating Instructions Installation Instructions Safety Instructions Installing the water heater. Hot and Cold Pipe Insulation Installation HOT FE I L ER EV L AV COLD HOT FE I L ER EV L AV COLD Typical vertical piping arrangement Typical horizontal piping arrangement Typical side piping arrangement For increased energy efficiency, some water heaters have been supplied with two 24" sections of pipe insulation. Please install the insulation, according to the illustrations above, that best meets your requirements. CAUTION: Ensure the T&P Valve opening is not obstructed by the insulation. Relief Valve Insulation Installation HOT FE I L ER EV L AV COLD Typical top connection arrangement For increased energy efficiency, some water heaters have been supplied with a 2-3/8" section of pipe insulation. Please install the insulation, according to the illustrations above, that best meets your requirements. Typical side connection arrangement Slip the insulation cover over the T&P Valve through the center hole and align the hole in the side with the opening of the T&P Valve. Heat Traps For increased energy efficiency, some water heaters have been supplied with factory installed heat traps in the hot outlet line and cold water inlet line. NOTICE: Do not apply heat to the HOT or COLD water connections. If sweat connections are used, sweat tubing to adapter before fitting adapter to the water connections on heater. Any heat applied to the water supply fittings will permanently damage the dip tube and/or heat traps. Care and Cleaning Troubleshooting Tips Customer Service 10