GE GSD2100N Owners Manual - Page 5

ge.com Control Settings Cycles POTS& PANS/ HEAVY WASH (on some modelsl For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included. This cycle will not remove burned-on foods. NORHAL/ For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Hang dishes have lighter NORMAL WASH soil than normal. Choosing a cycle other than NORMAL WASH will save energy and water. SHORT WASH For quicklg washing loads of everyday dishes with medium soils that have not dried on, such as loads (on some modelsl consisting mostly of glasses. WATER SAVER For dishes with light soils. LIG HT WASH (on some modelsl RINSEONLY For rinsing partial loads that will be washed later. Do not use detergent. DRYING For warming clean dishes and serving plates. This cycle will take approximately 30 minutes. PLATEWARMER HOT PREWASH Preheats wash water to the correct temperature. HOT START CHINA CRYSTAL For lightly soiled china and crystal. (on some models) OThpetliigohntsabove the selected pod will be ON to indicate which OPTIONhas been selected. HI TEMP Turns on the heater in all postrinse and final rinse cycles to help prevent spotting on dishware. This RINSE option may be turned ON or OFF during the wash cycle. on some models) HI TEMP Energizes the heater to boost water temperature in all prewash and main wash fill cycles. Recommended WASH for use with heavily soiled dishes. Option may be turned ON or OFF during the wash cycle. HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved. OFF HEATED DRY Turns the heater on for fast drying. This cycle will extend the time to your wash cycle by 30 minutes. ON NOTE: Cannot be selected with RINSEONLY cycle. LOCK on some modelsl When the LOCK pad is touched twice within 3 seconds, all pads become inoperative. Youcon lock the controls to prevent any selectionsfrom being made. Or you con lock the controls after you have started o cyde or selected DELAYSTARTso the cycle or DELAYSTARTis not interrupted. Children cannot occidentally start dishwasher by touching pods with this option selected. To unlock the dishwasher after it has been locked, touch the LOCK pad twice within 3 seconds. The light above the LOCKpad will turn off. DELAY HOURS on some models) You can delay the start of a wash cycle for up to 8 hours. Press the DELAY HOURS pad to choose the number of hours you want to delay the start of the cycle, then press START/RESETT. he machine will count down and start automatically at the correct time. Pressing START/RESETa second time will cancel the DELAY HOURS selection. NOTE: If you forget to fully close the door, a reminder signal will beep until you do so. RESET To change a cgcle after washing starts, touch the START/RESETpad to cancel the cycle. After water is on some modelsl pumped out and the motor stops, you can reprogram and restart the dishwasher. This will take approximately 90 seconds. NOTE: On GSD3900 model, the light above the selected pad will be ON to indicate which OPTION has been selected. @Start (Models with a Dial) Slowlg turn the Dialto the STARTor ON position,or the selectedcgcle.Don't turn it past the STARTO, N or cgcle position,or gou could accidentallg miss a rinse. There is a time delag between start-up and water fill so gou will not hear ang wash action right awag. ?_Latch the door to begin the cgcle.