GE GSD3360KSS Installation Instructions - Page 14

Step 19, Dishwasher Wet Test, Checklist

Page 14 highlights

Dishwasher Installation STEP 19: DISHWASHER WET TEST CHECKLIST • Turn on power supply or if power cord is used, plug it into the wall outlet. • Latch dishwasher door. • For electronic dishwashers, select the NORMAL WASH cycle and press the START pad one time. Cycles POTS & PANS HEAVY WASH NORMAL CHINA WASH CRYSTAL RINSE ONLY HI TEMP HI TEMP HEATED RINSE WASH DRY LOCK (2 TIMES) 248 DELAY HOURS CLEAN CLEAN START RESET - Check the electrical connection to the water valve. The red electrical connector should be plugged into the dishwasher water valve. If it LVQRWSOXJJHGLQWXUQRȺHOHFWULFDOSRZHUWR the dishwasher. Plug the red connector into the dishwasher water valve and then restore power. Red Connector • For dial models, press the NORMAL and HOT START pads, if model has them, and then turn the control dial just enough to start the dishwasher. %HFDUHIXOQRWWRWXUQWKHGLDOSDVWWKH¿UVWZDWHU ¿OO'LDOVKRXOGSRLQWWR´+RW6WDUW2SWLRQµRU´+RW Prewash Option" depending on model. Cycles Pots Heavy Normal Hot Hi-Temp Heated Reset & Pans Wash Wash Start Wash Dry Cycle on Hot Start Option Start Start Delay (HRS) 2 1 6 543 Off Plate Warmer (Heated Dry On) Rinse Only (Heated Dry Off) Light Wash Appearance varies by model. Not all models have push buttons. • Check to be sure that water enters the dishwasher. This could take up to 4 minutes. If water does not enter the dishwasher: - Check to be sure that the water is turned on. ²/LJKWO\WDSWKHÀRRGÀRDWFRYHUWRGLVORGJH  DVWXFNÀRRGÀRDW Flood Float Cover • Check for leaks under the dishwasher. If a leak is IRXQGWXUQRȺSRZHUWLJKWHQFRQQHFWLRQVDQG restore power. • Check for leaks around the door. A leak around the door could be caused by the dishwasher door rubbing or hitting adjacent cabinets. Reposition the dishwasher if necessary. See Steps 11, 12 and 13. • Most dishwasher models will drain about PLQXWHVDIWHUWKH¿UVW¿OO&KHFNWKHGUDLQOLQH for leaks when dishwasher drains. If leaks are IRXQGWXUQRȺSRZHUFRUUHFWDVQHFHVVDU\ and then restore power. • Open the dishwasher door and make sure most of the water has drained. If the water does not drain, check to be sure disposer plug has been removed and/or air gap is free of debris. ‡ /HWWKHGLVKZDVKHUUXQWKURXJKDQRWKHU¿OODQG drain cycle. Check again to be sure there are no leaks. • At the end of the second drain, push the reset pad on electronic models. For dial models, unlatch the GRRUDQGURWDWHWKHGLDOWRWKH´2ȺµSRVLWLRQ 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

Dishwasher Installation
Check the electrical connection to the water
valve. The red electrical connector should be
plugged into the dishwasher water valve. If it
the dishwasher. Plug the red connector into the
dishwasher water valve and then restore power.
Check for leaks under the dishwasher. If a leak is
restore power.
Check for leaks around the door. A leak around
the door could be caused by the dishwasher door
rubbing or hitting adjacent cabinets. Reposition
the dishwasher if
necessary. See Steps 11, 12
and 13.
Most dishwasher models will drain about
for leaks when dishwasher drains. If leaks are
and then restore power.
Open the dishwasher door and make sure most
of the water has drained. If the water does not
drain, check to be sure disposer plug has been
removed and/or air gap is free of debris.
drain cycle. Check again to be sure there are no
leaks.
At the end of the second drain, push the reset pad
on electronic models. For dial models, unlatch the
14
STEP 19:
DISHWASHER WET TEST
CHECKLIST
Turn on power supply or if power cord is used,
plug it into the wall outlet.
• Latch dishwasher door.
For electronic dishwashers, select the
NORMAL
WASH
cycle and press the
START
pad one time.
Check to be sure that water enters the
dishwasher. This could take up to 4 minutes.
If water does not enter the dishwasher:
– Check to be sure that the water is turned on.
Flood Float
Cover
For dial models, press the
NORMAL
and
HOT
START
pads, if model has them, and then turn the
control dial just enough to start the dishwasher.
Prewash Option” depending on model.
Hi-Temp
Wash
Heavy
Wash
Pots
&
Pans
Cycles
Normal
Wash
Hot
Start
Heated
Dry
Hot Start
Option
Start Delay
(HRS)
Cycle
on
Off
1
3
2
4
6
5
Plate
Warmer
(Heated Dry On)
Rinse Only
(Heated Dry Off )
Start
Light
Wash
Reset
H
EAVY
W
ASH
P
OTS
&
P
ANS
Cycles
N
ORMAL
W
ASH
C
HINA
C
RYSTAL
R
INSE
O
NLY
S
TART
R
ESET
C
LEAN
C
LEAN
HI T
EMP
R
INSE
HI T
EMP
W
ASH
H
EATED
D
RY
D
ELAY
H
OURS
L
OCK
(2 T
IMES
)
2
4
8
Appearance varies by model. Not all models have push buttons.
Red Connector