GE GSD3360KSS Installation Instructions - Page 8

Dishwasher Installation STEP 5: INSTALL POWER CORD Skip this step if the dishwasher will be permanently connected to the house electrical system or has a factory-installed power cord. In this step you will need the junction box cover and the #10 x 1/2" hex-head screw from the screw kit set aside in Step 1. The power cord and connections must comply with the National Electrical Code, Section 422 and/ or local codes and ordinances. Maximum power cord length is 6 feet. Power Cord Kit WX09X70910 or WX09X70911, available for purchase from an authorized GE appliance dealer, meets these requirements. STEP 6: INSTALL 90° ELBOW OR FERRULE (DEPENDING ON MODEL) 90° ELBOW MODELS • Ensure rubber gasket is located between valve and elbow. • Thead the 90° elbow onto the water valve. FERRULE MODELS • Wrap the ferrule with thread seal tape. • Thead the ferrule into the water valve. Water Valve Bracket Water Valve Bracket Gasket 90° Elbow Fill Hose Tape Ferrule Fill Hose Figure K • Do not over tighten the elbow/ferrule; water valve EUDFNHWFRXOGEHQGRUWKHYDOYH¿WWLQJFRXOGEUHDN • Position the end of the elbow/ferrule to face the rear of the dishwasher. Junction Box Bracket Ground White Black STEP 7: INSTALL DRAIN HOSE TO DISHWASHER DRAIN PORT Skip this step if drain hose has been preinstalled. In this step you will need the drain hose and clamp set aside in Step 1. Cover Strain Relief and Dishwasher Wires • Install strain relief in the junction box bracket. • Insert the power cord through the strain relief and tighten. • Make sure black, white and green dishwasher wires are threaded through the small hole in the junction box bracket. • Connect power cord white (or ribbed) to dishwasher white, black (or smooth) to dishwasher black and ground to dishwasher green wire. Use UL-listed wire nuts of appropriate size. • Install junction box cover using the #10 hex-head screw. Be sure wires are not pinched under the cover. 8 IMPORTANT - Prevent drain hose damage and possible leaks. Be careful not to nick or cut the drain hose. • Route the small end of the drain hose from the left side of the dishwasher through the strain relief attached to the dishwasher frame and toward the center of the dishwasher as shown in Figures L and M. • Place the hose clamp over the small end of the drain hose. • Push the small end of the drain hose over the drain port on the collection chamber, making sure it is fully seated against the hose stop. • Tighten the hose clamp to at least 15 inch-pounds of torque.