GE GTD65EBSJWS Installation Instructions - Page 11

Installation Instructions SIDE OR BOTTOM VENTING TAB LOCATION WARNING - Fire Hazard Close the back opening with cover plate (Kit WE1M454). Disconnect dryer from electrical supply. Wear gloves and arm guards. Failure to do so may result in fire, electrical shock or lacerations. Right Remove screw and save BEND TAB UP 45 o Through the rear opening, locate the tab in the middle of the appliance base. Lift the tab to about 45°, using a flat-blade screwdriver. ADDING A NEW DUCT Fixing hole Portion "A" Left Bottom Remove desired knockout (one only) Detach and remove the right, left or bottom knockout as desired. Remove the screw inside the dryer exhaust duct and save. Pull the duct out of the dryer. Fixing hole A 9-1/2" (24.13cm) For models GTD60, GTD65 and GTD68 only, use the dimension below. Fixing hole A 10-1/2" (26.67cm) Cut the duct as shown and keep portion A. Right or left side exhaust Reconnect the cut portion (A) of the duct to the blower housing. Make sure that the shortened duct is aligned with the tab in the base. Use the screw saved previously to secure the duct in place through the tab on the appliance base. ADDING ELBOW AND DUCT FOR EXHAUST TO LEFT OR RIGHT SIDE OF CABINET Exhaust can be added to left or right Duct tape • Preassemble 4" elbow with 4" duct. Wrap duct tape around joint. • Insert duct assembly, elbow first, through the side opening and connect the elbow to the dryer internal duct. Be sure not to pull or damage the electrical wires inside the dryer when inserting the duct. 11