GE GTX22EASKWW Installation Instructions - Page 1

Installation Instructions Dryers 05 Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com This is the safety alert symbol. This symbol alerts you to potential hazards that can kill you or hurt you and others. All safety messages will follow the safety alert symbol and the word "DANGER", "WARNING", or "CAUTION". These words are defined as: DANGER Indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING Indicates a hazardous situation which, if not avoided, could result in death or serious injury. CAUTION Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local electrical inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Install the clothes dryer according to the manufacturer's instructions and local codes. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Clothes dryer installation must be performed by a qualified installer. • This dryer must be exhausted to the outdoors. • Before the old dryer is removed from service or discarded, remove the dryer door. • Service information and the wiring diagram are located in the control console. • Do not allow children on or in the appliance. Close supervision of children is necessary when the appliance is used near children. • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. • Install the dryer where the temperature is above 50°F for satisfactory operation of the dryer control system. • Remove and discard existing plastic or metal foil duct and replace with UL-listed duct. WARNING - Fire Hazard • Clothes dryer installation must be performed by a qualified installer. • Install the clothes dryer according to these instructions and local codes. • DO NOT install a clothes dryer with flexible plastic venting materials. If flexible metal (semi-rigid or foil-type) duct is installed, it must be UL-listed and installed in accordance with the instructions found in "Connecting the Dryer to House Vent" later in this manual. Flexible vent materials are known to collapse, be easily crushed and trap lint. These conditions will obstruct dryer airflow and increase the risk of fire. • DO NOT install or store this appliance in any location where it could be exposed to water or weather. • To reduce the risk of severe injury or death, follow all installation instructions. • Save these instructions. (Installers: Be sure to leave these instructions with the customer.) Printed in Mexico 234D2318P005 31-16775 10-15 GE