GE JGP333SETSS Installation Instructions - Page 13
Installation Instructions, MAKING THE LP CONVERSION - gas cooktop
View all GE JGP333SETSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Instructions MAKING THE LP CONVERSION IF SOLD OUTSIDE THE U.S. AND CANADA: WARNING: If you wish to use this product with Liquefied Petroleum (LP) gas containing greater than 10% butane, you must purchase a butane conversion kit. To order, please call 1.888.664.8403 or 1.787.276.4051. Model JGP940 JGP333 & PGP943 JGP329 Butane Kit # WB28T10228 WB28T10283 WB28T10234 1 SAFETY INFORMATION YOU SHOULD KNOW The pressure regulator and burner orifices are set for natural gas. To use LP gas, the regulator and burner orifices must be converted. The LP orifice spuds for the cooktop burners can be located in the literature package attached to the regulator. CAUTION: The cooktop, as shipped from the factory, is set for use with natural gas. If you wish to use your cooktop with LP gas, you must first replace the orifices and convert the pressure regulator. WARNING: This conversion must be performed by a qualified installer or gas supplier in accordance with the manufacturer's instructions and all codes and requirements of the authority having jurisdiction. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion. CAUTION: The following adjustments must be made before turning on the burner. Failure to do so could result in serious injury. Be sure pressure regulator has been converted as described in Step 2. TOOLS YOU WILL NEED FOR LP CONVERSION Phillips-Head Screwdriver 7mm Nutdriver Pliers Safety Glasses No. 15 Torx-Head Driver Small Flat-Head Screwdriver (4mm or 5/32″ tip size, 60mm long) 2 ADJUST YOUR COOKTOP FOR USE WITH LP GAS A Disconnect all electrical power, at the main circuit breaker or fuse box. B Shut off the gas supply to the cooktop by closing the manual shut-off valve. C Adjust the pressure regulator, by the following instructions: • Unscrew the cap. • Place your thumb against the flat side of the spring retainer and press down to remove the retainer. • Carefully look at the spring retainer to locate the NAT or LP position. Cap Gasket LP LP NAT NAT NAT. Position LP Spring Retainer LP L.P./Propane Position DOWN FOR OFF NAT NAT Pressure Regulator • Turn the spring retainer over so that LP is showing on the bottom. • Snap the retainer back into position. • Screw the cap back onto the regulator. 13