GE JGP975SEKSS Use and Care Manual - Page 11

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.com Burner cap properly seated Burner cap not properly seated Burner Head and Cap Replacement Replace the burner head onto the burner base, making sure that the head is properly oriented over the burner base and the electrode. Make sure to place the correct burner head on the correct burner base and that the burner head sits level on the burner base. The burner heads are not interchangeable. Replace the burner cap onto the burner head, making sure to place the correct burner cap on the correct burner head. The burner caps are not interchangeable. Also, make sure that the burner caps are properly seated on the burner heads. JGP940 and JGP970 (all burners) JGP933 and JGP963 (right front burner only) Burner cap JGP328, JGP330, JGP628, JGP630, JGP933, JGP945, JGP963, JGP975 Burner cap JGP945 and JGP975 (right front burner only) Burner cap Locator pins Burner head Stability chamber Electrode Burner head Electrode Burner head assembly Orifice Pin indentations Burner base Make sure the pins in the burner heads match the burner base indentations and that they are properly seated in them by rotating the heads until they are level. Burner base Make sure the slot in the burner head is positioned over the electrode. The burner cap has three to four pins. When replacing the cap, make sure none of the pins sits in the stability chamber. Electrode Burner base Make sure the hole in the burner head assembly is positioned over the electrode and that the burner head is fully inserted inside the burner base. A small gap between the base and head is normal. Burner Grates (On some models) "OUTSIDE" "INSIDE" edge edges "OUTSIDE" edge (On some models) "INSIDE" edges Your cooktop has professional style grates. These grates are designed for specific positions. These grates should only be used in their proper positions; they should not be interchanged. For your convenience, the undersides of the left and right grates are marked "OUTSIDE" and "INSIDE". Make sure that the sides marked "OUTSIDE" are facing the outer edge of the cooktop and the sides marked "INSIDE" are facing each other. All grates should touch once they are fully assembled on the cooktop surface. "OUTSIDE" edge Tabs "OUTSIDE" edge For cooktops with three grates, make sure that the tabs on either side of the center grate fit into the slots located on the "INSIDE" edge of the side grates. Lift the burner grates out only when cool. Grates should be washed regularly and, of course, after spillovers. Wash them in the dishwasher or in hot, soapy water and rinse with clean water. When replacing the grates, be sure they are positioned securely over the burners. Although they are durable, the grates will gradually lose their shine, regardless of the best care you can give them. This is due to their continual exposure to high temperatures. You will notice this sooner with lighter color grates. Do not operate a burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat. NOTE: Do not clean the grates in a self-cleaning oven. 11