GE JKP86BFBB User Manual - Page 35

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Socket 31⁄2" Maximum length Bulb Tab Glass cover ge.com Lower Oven Light Bulb (on some models) NOTE: The glass cover (on some models) should be removed only when cold. Wearing latex gloves may offer a better grip. Before replacing the bulb, disconnect electrical power to the oven at the main fuse or circuit breaker panel. Let the bulb cool completely before removing it. For your safety, do not touch a hot bulb with a damp cloth. If you do, the bulb will break. To replace: Put in a new 40-watt appliance bulb. Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn. NOTE: s A 40-watt appliance bulb is smaller than a standard 40-watt household bulb. s Install and tighten the cover clockwise. To remove: Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket. Remove the bulb. s Reconnect electrical power to the oven. s For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool. Receptacle Socket Bulb Tab Glass cover Lower Oven Light Bulb (on some models) NOTE: The glass cover (on some models) should be removed only when cold. Wearing latex gloves may offer a better grip. CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely. For your safety, do not touch a hot bulb with bare hands or a damp cloth. To remove: Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket. Using gloves or a dry cloth, remove the bulb by pulling it straight out. To replace: Use a new 130-volt halogen bulb, not to exceed 50 watts. Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers. Receptacle Use gloves or cloth Push the bulb straight into the receptacle all the way. Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn. For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool. Reconnect electrical power to the oven. 35