GE JRP20SKSS Installation Instructions - Page 4

INSTALLING OVEN To remove the oven door: 1. Open the door to the stop position (see Fig. 3A). 2. Grasp the door at each side and lift up and off the hinges (see Fig. 3B). CAUTION: When the door is removed and hinge STOP! arms are at stop position, do not bump or try to move the hinge arms. The hinges could snap back causing an injury to the hands or damage to the porcelain on the front of the range. Cover the hinges with toweling or empty towel rolls while working in the oven area. 3. Put the oven into the cabinet and use a 1/8" drill bit to drill holes in the cabinet front through the holes in the oven trim. 4. Secure the oven in the cabinet with the screws provided. 5. The lower trim should be mounted to the bottom of the oven frame with the 3 screws provided. The lower front trim is packed separately and should be added after the oven is installed. The oven door must be removed to install the lower trim. REPLACE THE OVEN DOOR 1. Hold the door over the hinges with the slots at the bottom edge of the door lined up with the hinges. 2. Slide the door down onto the hinges as far as it will go and close the door. STOP POSITION Fig. 3A HINGE Fig. 3B The trim provides cooling air entry into cabinet through the bottom opening. STOP! The bottom opening should never be blocked. See Fig. 3B. Recycled Paper 4 - Printed in the United States -