GE JVM1540SPSS Installation Instructions - Page 13
Preparation of Top Cabinet, Check for Proper Damper Operation, Mount the Microwave Oven
UPC - 084691177265
View all GE JVM1540SPSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Instructions A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. A4. MOUNT THE MICROWAVE OVEN • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. A3. CHECK FOR PROPER DAMPER OPERATION Damper CAUTION: FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Blower Plate Exhaust Adaptor Retaining Hooks Back of Microwave Oven • Place the microwave in its upright position, with the top of the unit facing up. • Make sure tape securing damper is removed and damper pivots easily before mounting microwave. • Slide the damper into place. Make sure it catches in the retaining hooks to secure. • You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed. 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. 13