GE JVM1540SPSS Installation Instructions - Page 17

Installation Instructions B4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST (cont.) 4 Rotate blower unit counterclockwise 180°. Before Rotation After Rotation 7 Place the blower unit back into the opening. AFTER: Fan Blade Openings Facing Back End A End B Back of Microwave Oven Back of Microwave Oven 5 Gently remove the wires from the grooves. Reroute the wires through grooves on other side of the blower unit. Before Rerouting After Rerouting CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven. 8 Secure the blower to the microwave oven using the retaining screw from Step 2. Blower Wires Routed Through Right Side Wires Routed Through Left Side 6 Roll the blower unit 90° so that fan blade openings are facing out the back of the microwave. Before Rolling After Rolling Back of Microwave Oven Back of Microwave Oven Back of Microwave Oven Blower Retaining Screw 9 Slide the exhaust adaptor onto the back of the microwave oven, securing it into the lower locking tabs. Take care to ensure that the damper hinge is installed so that it is at the top and that the damper swings freely. Reinstall the upper blower motor screw through the adaptor and the blower door and into the back of the microwave oven. Close the blower door and secure it using the screw from Step 1. Blower Retaining Screw Back of Microwave Oven Guide Adaptor Locking Tabs (not shown) Guide Blower Motor Door Retaining Screw 17