GE JX1530 Installation Instructions - Page 1
GE JX1530 - Profile 30 in. Deluxe Trim Manual
View all GE JX1530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions Built-In Trim Kits JX1527 JX1530 Questions? In the U.S., call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com. In Canada, call 1.800.561.3344 or Visit our Website at: GEAppliances.ca. ❒ BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Skill level - Installation of this appliance requires basic mechanical and electrical skills. • Completion time - 1 to 3 hours • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. • This kit is UL/CSA listed for installation alone or over any GE/GE Profile single electric wall oven. Not for use adjacent to (within 2 feet of) any gas or electric range, cooktop or oven. • For easier installation and personal safety, we recommend that two people install this microwave oven. • Unplug the microwave oven before attempting installation of this kit. • This kit is for use on models: PEB1590DMBB, PEB1590DMWW, PEB1590SMSS, PEB159CDNBB, PEB159CSNSS and PEB159CDNWW. • Do not alter or modify any part of this kit or the oven. WARNING - This oven must be plugged into a properly grounded 3-hole, 120V receptacle as required by the National Electrical Code or Canadian Electrical Code. PARTS INCLUDED PART ❒ Trim Frame QUANTITY 1 ❒ Bottom Duct 1 ❒ Top Bracket 1 ❒ Bottom Bracket 1 ❒ Upper Duct 1 ❒ Rear Duct 1 ❒ 4 mm x 14 mm Round-Head Screws ❒ 4 mm x 14 mm Flat-Head Screws ❒ Anti-Tip Brace 22 required 2 extra 4 required 2 extra 1 FOR YOUR SAFETY: WARNING - Before beginning the installation, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. ❒ Anti-Tip Bracket 1 ❒ Template 1 NOTE: This kit has extra screws to prevent the technician from spending extra time locating a replacement screw during installation. READ CAREFULLY. 1 KEEP THESE INSTRUCTIONS.