GE NX-1448E User's Manual - Page 25

KEYPAD CONTROL TONES (BEEPS) A sounder is built into the keypad. If programmed, your system keypad may sound for any of the following reasons: Beeps for all keypresses. Sounds a continuous tone during the Entry delay time. Pulses when a day zone is violated while the system is disarmed. Pulses when a FIRE zone has a trouble condition. Beeps 3 times for trying to arm with the "Not Ready" icon off, if "Force Arming" has not been selected. Beeps for 1 second or emits a "ding-dong" sound for the "Chime" feature. Beeps during an exit delay; beeps rapidly for the last 10 seconds of an exit delay; and beeps 1 second at the end of the exit delay. Pulses when the armed status changes and the AC power is off. Pulses when the armed status changes and any zone(s) are bypassed. Pulses when the armed status changes and a low battery is detected. Pulses when the armed status changes and a Tamper condition is detected. Beeps to indicate Telephone Line Cut, if selected. Pulses when one or more of the following conditions are detected: Zone or Box Tamper, Low Battery, AC Power Fail, or Expander trouble. Beeps 3 times once every minute for Sensor/Zone Low Battery or Loss of Supervision. Entering a code will silence the keypad for 12 hours. Entering a valid code will silence the keypad sounder when it is pulsing. The arm/disarm state of your system will not change when entering a code to silence a pulsing keypad sounder. Please contact your installer if a trouble condition exists. NX1448E Icon Keypad Page 25