GE PDWT580PSS Owners Manual - Page 7
Flashing display lights., Recommended dishwasher products. - profile
View all GE PDWT580PSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ge.com Ll start (continued) Top-Control Dishwashers After selecting the cycle and desired enhancements, touch the START/RESETpod to ready the dishwasher to begin the cycle. Closethe door to start the cycle or begin the DELAVSTARTcountdown. When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins. The dishwasher will always display your lost selection and enhancements. If you don't wont to change the settings, simply touch the START/RESEpTod to ready the dishwasher and close the door to begin the cycle. Also, ifo power failure occurs NORMALand HEATEDDRYwill automatically be programmed. Hake any new selections and touch the START/RESEpTod to begin the new cycle. When the door is opened, the indicator lights will turn off if the START/RESETpadis not selected within 5 minutes. To activate the display, open and close the door or touch any pad. D Clean Front-Control Dishwasher The CLEANlight is illuminated when the selected cycle and enhancements ore complete. The light will stay ON until o pod is pressed or the door is opened and then closed. Top-Control Dishwasher The CLEANlight is illuminated and o double beep will sound when the selected cycle and enhancements ore complete. You may remove the dishes at any time. The high-efficiency fan will run quietly for 30 minutes to 4 hours (depending on selected cycle) offer the CLEAN light is illuminated to continue drying the dishes.The fan con be turned off by opening the door and pressing any keypad. ALL MODELST: o turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off), press the HEATEDDRYpod 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled. Flashing display lights. Status Indicator Lights START/RESET What It Means Cycle has been interrupted by pressing the START/RESETpod, or there has been o power failure. Light will stop flashing offer the dishwasher automatically drains out the water. The dishwasher will restart if the interruption was the result of o power failure. Recommended dishwasher products. GErecommends the following products for use in its dishwashers: Foryour manual detergent dispenser,Cascade® and ElectrasoF powder, liquid or gel automatic dishwasher detergents ore approved. Foryour SmortDispenseTM Detergent Dispenser,use only the recommended detergents listed on page 10 of this manual. • Cascade®Plastic BoosteffMto remove red staining inside your dishwasher that con come from some tomato-based foods. • Cerama Bryte ®StainlessSteelAppliance Cleaner to cleon the exterior stainless steel panel of GEand ProfileTM dishwashers (for stainless steel exterior models only). Jet Dry ®or Cascade Crystal Cleare rinse agents to remove spots and prevent new film buildup on your dishes,glosses,flatware, cookwore and plastic. Using rinse agent also improves dry performance.