GE PGB916SEMSS Installation Instructions - Page 40
Oven Light Replacement, Shelves, Drawer, CAUTION, To remove, Do not remove any screws to remove
UPC - 084691166320
View all GE PGB916SEMSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Operating Instructions Safety Instructions Care and cleaning of the range. Oven Shelves and Drawer Racks If your oven is equipped with nickel oven shelves, they should be removed from the oven before beginning the self-clean cycle. To clean the nickel shelves, use an abrasive cleanser. After cleaning, rinse the shelves with clean water and dry with a clean cloth. If the shelves ever become hard to slide, wipe the shelf edges or oven shelf supports with vegetable oil. If your oven is equipped with gray porcelaincoated shelves, they may be cleaned in the oven during the self-clean cycle. They may also be cleaned by using an abrasive cleanser. After cleaning, rinse the shelves with clean water and dry with a clean cloth. If the shelves ever become hard to slide, wipe the shelf edges or oven shelf supports with vegetable oil. Wire cover holder. Oven Light Replacement CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely. The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped wire. Remove the oven door, if desired, to reach cover easily. To remove: Hold a hand under the cover so it doesn't fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover. Do not remove any screws to remove the cover. Do not touch hot bulb with a wet cloth. Replace bulb with a 40-watt household appliance bulb. To replace cover: Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire is in the depression in the center of the cover. Connect electrical power to the range. The storage drawer may be removed for cleaning under the range. Removable Storage Drawer (on some models) The storage drawer is a good place to store cookware and bakeware. Do not store plastics and flammable material in the drawer. The storage drawer may be removed for cleaning under the range. Clean the storage drawer with a damp cloth or sponge. Never use harsh abrasives or scouring pads. To remove storage drawer: Pull drawer straight out until it stops. Tilt the front of the drawer up and free of the range. To replace storage drawer: Set the stops on the back of the drawer over the stops in the range. Slide drawer evenly and straight back, so that the rails in the range are engaged. Installation Instructions Consumer Support Troubleshooting Tips 40