GE PGP990SENSS Quick Specs - Page 1
GE PGP990SENSS Manual
UPC - 084691171089
View all GE PGP990SENSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
PGP990SEN GE Profile™ Built-In Downdraft Gas Cooktop Dimensions and Installation Information (in inches) Wall Installation: Wall installations require 25" countertop depth. When cabinet is flush against the wall, the fan housing can be rotated to the horizontal position for direct venting through rear wall. Make a countertop cutout in the range cabinet according to unit dimensions and installation type. Duct hole is positioned in back of cabinet for through-the-wall ducting. Requires special offset adapter JXRW89. Peninsula or Island Installation: For peninsula/islands a minimum 26" countertop depth is suggested. Blower should be in vertical position. Island or peninsula cabinets may require adjustment in cutout depth and/or location within the width dimensions. Duct hole is positioned in bottom of cabinet for island or peninsula installation. Slab Installation: For peninsula or island installation and rear wall ducting, 6" PVC duct or locally approved piping should be used if installing under a poured concrete slab. Installation Information: Before installing, consult installation instructions, packed with product, for current dimensional data. Note: These cooktops are approved for indoor use only. Warranty Information: Parts Warrany - Limited 1-year entire appliance Labor Warranty - Limited 1-year entire appliance Warranty Notes - For models produced on or after January 1, 2006; see written warranty for full details For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. 30 21-3/4 Tie down bolt on each end Blower can be swiveled 90° Grease container Pressure regulator Wiring box cover 15/16" Min. clearance 29 ±1/16 21 ±1/16 9 9-1/2 14-3/16 1-7/8" Min. Select appropriate duct cutout (see ducting installation instructions). Listed by Underwriters Laboratories Specification Revised 7/10 230283