GE PGP990SENSS Quick Specs - Page 2
GE Profile, Built-In Downdraft Gas Cooktop - profile downdraft cooktop
UPC - 084691171089
View all GE PGP990SENSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
PGP990SEN GE Profile™ Built-In Downdraft Gas Cooktop Dimensions and Installation Information (in inches) Installing the Ductwork: Use galvanized or aluminum duct in 6" round or 3-1/4" x 10" size, or combination of both. PVC duct or locally approved piping should be used if installing under a poured concrete slab. Local building code must be followed in specifying type and schedule of all duct used. Note: Ductwork must be vented to outside. Do not vent into a wall, ceiling, crawlspace, attic or any concealed space. Always use an appropriate roof or wall cap with damper. Laundry-type wall caps should never be used. For maximum efficiency use the shortest and straightest duct run possible, with as few fittings as possible. For satisfactory performance the duct run should not exceed 100 feet equivalent length. Refer to the table of equivalent lengths (shown in installation instructions) for various duct configurations. Through Cabinet Toe Space Venting Options Between Floor Joist Inside Wall to Roof Direct to Outside For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. Listed by Underwriters Laboratories Specification Revised 7/10 230283