GE PGS908SEPSS Use and Care Manual - Page 35
Care and Cleaning
UPC - 084691199786
View all GE PGS908SEPSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.com (U.S.) www.GEAppliances.ca (Canada) Cleaning the Oven Door To clean the inside of the door: Do not rub or clean the door gasket- it has an extremely low resistance to abrasion. If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced. ■ Because the area inside the gasket is cleaned during the self-clean cycle, you do not need to clean this by hand. ■ The area outside the gasket and the door liner can be cleaned with a soap-filled or plastic scouring pad, hot water and detergent. Rinse well with a vinegar and water solution. To clean the outside of the door: ■ Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door. Do not let water drip into the vent openings. ■ If any stain on the door vent trim is persistent, use a soft abrasive cleaner and a sponge-scrubber for best results. ■ Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse. ■ Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door. Slot Hinge lock Pull hinge locks down to unlock. Removal position Lift-Off Oven Door The door is very heavy. Be careful when removing and lifting the door. Do not lift the door by the handle. To remove the door: Fully open the door. Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat-blade screwdriver, may be required. Firmly grasp both sides of the door at the top. Close door to the door removal position, which is halfway between the broil stop position and fully closed. Lift door up and out until the hinge arm is clear of the slot. To replace the door: Firmly grasp both sides of the door at the top. With the Bottom door at the same angle as edge of slot Hinge arm the removal position, seat the indentation of the hinge arm Indentation into the bottom edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot. Push the hinge locks up against the front frame of the oven cavity to the locked position. Hinge arm Hinge lock Push hinge locks up to lock. Close the oven door. Oven floor Removable Oven Floor To remove the oven floor for easier cleaning: Remove the oven door using the instructions in the Lift-Off Oven Door section. Clean the oven floor with warm soapy water. IMPORTANT: Always replace the removable floor before the next use. Grasp oven floor slots on each side and pull it out. 35