GE PP972SMSS Installation Instructions - Page 1

GE PP972SMSS - Profile 36" Smoothtop Electric Cooktop Manual

Page 1 highlights

Installation 36" Electric Cooktop Instructions CP650, JP655, PP962, PP972, PP975, PP980, ZEU36K "If you have questions, call 800.GE.CARES or visit our website at: ge.com" Before You Begin Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Product failure due to improper installation is not covered under the Warranty. WARNING - This appliance must be properly grounded. • A TTENTION INSTALLER - ALL COOKTOPS MUST BE HARD WIRED (DIRECT WIRED) INTO AN APPROVED JUNCTION BOX. A "PLUG AND RECEPTACLE" IS NOT PERMITTED ON THESE PRODUCTS. • Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty. MATERIALS YOU WILL NEED Junction Box Wire Nuts TOOLS YOU WILL NEED Pencil Phillips Head Screwdriver Ruler or Straightedge Saber Saw 1/8≤ Drill Bit & Electric or Hand Drill Safety Glasses PARTS INCLUDED 4 Screws (WB1X1137) Foam Tape 2 Hold Down Brackets 31-10636-2 (11-10 GE) 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

1
TOOLS YOU WILL NEED
MATERIALS YOU WILL NEED
Installation
36" Electric Cooktop
Instructions
BEfORE YOU BEgIN
Read these instructions completely
and careFully.
IMPORTANT
Save these instructions
for local inspector’s use.
IMPORTANT
Observe all governing
codes and ordinances.
Note to Installer –
Be sure to leave these
instructions with the Consumer.
• Note to Consumer –
Keep these instructions for
future reference.
Product failure due to improper installation is not
covered under the Warranty.
WARNINg
This appliance must be
properly grounded.
ATTENTION INSTALLER
ALL
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX. A
“PLUg AND RECEPTACLE” IS NOT PERMITTED
ON THESE PRODUCTS.
Proper installation is the responsibility
oF the installer and product Failure due to
improper installation is NOT covered under
warranty.
Wire Nuts
Junction Box
Saber Saw
Pencil
Safety Glasses
1/8
Drill Bit & Electric or
Hand Drill
Ruler or Straightedge
Phillips Head
Screwdriver
CP650, JP655, PP962, PP972, PP975, PP980, ZEU36K
“IF you have questions, call 800.gE.CARES
or visit our website at: ge.com”
PARTS INCLUDED
2 Hold Down
Brackets
4 Screws
(WB1X1137)
Foam Tape
31-10636-2
(11-10
GE)