GE PSW23PSWSS Owners Manual - Page 15

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support About the ice and water dispenser. (on some models) ge.com Spill Shelf To Use the Dispenser Select CUBED, CRUSHED or WATER. Press the glass gently against the top of the dispenser cradle. The spill shelf is not self-draining. To reduce water spotting, the shelf and its grille should be cleaned regularly. If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the dispenser arm for at least two minutes to remove trapped air from the water line and to fill the water system. To flush out impurities in the water line, throw away the first six glassfuls of water. CAUTION: Never put fingers or any other objects into the ice crusher discharge opening. Locking the Dispenser Press the LOCK pad for 3 seconds to lock the dispenser and control panel. To unlock, press and hold the pad again for 3 seconds. Dispenser Light The LIGHT pad turns the night light in the dispenser on and off. The light also comes on when the dispenser cradle is pressed. On some models, if this light burns out, it should be replaced with a 6 watt 12V maximum bulb. Door Alarm Use Door Alarm to sound if either door is open for more than 3 minutes. The alarm will stop once the door is closed. For LCD models, a popup screen will appear. The alarm can be silenced by touching the LCD screen. LCD Models: Access By: Home > Options > Information and Settings > Settings > Door Alarm Access By: Pressing ON. Deactivate By: Pressing OFF. Non-LCD Models: Press the DOOR ALARM pad until the indicator light comes on. Quick Ice When you need to speed up ice production, use the Quick Ice feature. While this feature is turned on, the freezer fan runs continuously for 48 hours, or until the feature is turned OFF. During this period, ice production will increase up to 40%. Models with the integrated ice feature system require at FIRST USE at least half an 8 oz. glass of ice to be dispensed every 6 to 12 hours. This will help the icemaker fill the bucket properly so that dispensing is better. How to Use LCD Models: Access by: Home > Options > Freezer Options > Quick Ice Activate by: Pressing ON. Deactivate by: Pressing OFF. Non-LCD Models: Press the QUICK ICE pad to turn the feature ON. Press the pad again to turn the feature OFF. Precise Fill (on some models) This water dispenser is equipped with a feature called "precise fill." This feature allows you to choose a precise amount of water (cups or ounces) that you would like dispensed. Pints and Liters are also available for LCD models. LCD Models Access By: Home > Options > Dispenser Options > Precise Fill > Set Amount Activate By: Using the arrow buttons to select the desired amount. Press MORE UNITS to select between CUPS, OUNCES, PINTS or LITERS. Non-LCD Models Press the WATER pad. Press the CUPS or OUNCES pad. Select the precise amount of water you would like dispensed. If you selected OUNCES, press the arrow pads on either side of the display to select the number of ounces you would like to have dispensed between 1-99 ounces. If you selected CUPS, press the arrow pads on the left of the display to select the whole cups (1-16 cups) and/or the arrow pads on the right side of the display to select fractions of a cup (1/4-3/4 cups). Press the cup against the cradle and water will begin dispensing. It will automatically stop when the amount set has been dispensed. The display will show there is no water left to dispense, then reset. NOTE: Do not leave the dispenser unattended when water is being dispensed. If you would like to stop dispensing water before the specified amount has been dispensed, just remove the cup from the cradle. The display will show the amount left to dispense. 15