GE PT960SMSS Owners Manual - Page 41
Racks, Standard Racks, Extension Rack - stainless steel
![]() |
View all GE PT960SMSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.com Standard Racks The standard racks may be cleaned by hand with an abrasive cleaner or steel wool. After cleaning, rinse the racks with clean water and dry with a clean cloth. They may also remain in the oven during the self-cleaning cycle without being damaged. If they become hard to slide, wipe their side edges and the oven rack supports with cooking oil after cleaning them by hand or in the oven. This will help maintain the ease of sliding the racks in and out of the oven. Extension Rack Porcelain enamel surfaces of the extension rack may be cleaned by hand with an abrasive cleaner or steel wool. Do not use a steel wool pad to clean stainless steel surfaces of the extension rack; it will scratch the surface. See Stainless Steel Surfaces in this Care and cleaning section. NOTE: Do not clean in a dishwasher. The rack may also remain in the oven during the self-cleaning cycle without being damaged. If the rack becomes hard to remove or replace, wipe the oven rack supports with cooking oil. Do not wipe cooking oil on the slides. If the rack becomes difficult to slide or if the release levers become difficult to use, the rack may need to be lubricated using the Graphite Lubrication shipped with your oven. To order additional Graphite Lubrication, call our National Parts Center at 800.626.2002 and reference WB02T10303. To lubricate the slides: NOTE: Do not spray extension rack with cooking spray or other lubricant sprays. Remove the rack from the oven. See Extension Rack in the Using the oven section. Fully extend the rack on a table or countertop. Newspaper may be placed underneath the rack for easy cleanup. If there is debris in the slide tracks, wipe it away using a paper towel. NOTE: Any graphite lubricant wiped away must be replaced. Shake the graphite lubricant before opening it. Starting with the left slide mechanism of the rack, place four (4) small drops of lubricant on the two (2) bottom tracks of the slide close to the bearing carriers. Left side Rack right-side-up Repeat for the right slide mechanism of the rack. Right side Rack right-side-up Open and close the rack several times to distribute the lubricant. Replace the cap on the lubricant and shake it again. Turn the rack over and repeat steps 3, 4, 5 and 6. Close the rack, turn rack right-side- up and place in the oven. See Extension Rack in the Using the oven section. To lubricate the release levers: Shake lubricant and apply to the moving parts of the release levers and paddle mechanisms. 41
![](/manual_guide/products/general-electric-pt920smss-owners-manual-d0e2691/41.png)