GE PTDN805GMMS Use and Care Manual - Page 31
WARNING, Installation Instructions, FINAL SETUP
UPC - 084691226239
View all GE PTDN805GMMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
FINAL SETUP Installation Instructions 1 LEVEL THE DRYER Stand the dryer near the final location. Place a level against the side and bottom of the dryer door frame and use the four leveling legs to level your dryer. 4 DUCT CONDITION TEST Press DAMP AlERT and TEMP together and don't release, then press POWER in idle state with no load in the dryer drum. Your dryer has an innovative duct blockage monitoring system that automatically monitors, detects, and alerts you when blockages occur in your ductwork. The dryer will show InS in the number display to indicate that it is in duct dondition testing mode. Press the START/PAUSE button. The dryer will run approximately 2 minutes to test for blockages or restrictions to the air flow in the ductwork. IMPORTANT: Do NOT interrupt the test cycle! Raise Lower 2 PLUG IN DRYER Ensure proper ground exists before use. If you observe "CLg" in the display window you must clean your exhaust ducting before you complete installation. Check exhaust ducting for obstructions or blockages, especially around turns. Contact a qualified service provider if necessary. After testing, press the POWER button to end test. NOTE: When the dryer is first installed, this test should be performed to alert you of any existing problems with the exhaust duct in your home. However, during normal usage with any cycle, your dryer keeps automatically detecting duct blockage and displays "CLg" in blocked condition. 3 DRYER STARTUP Press the POWER button. SERVICING WARNING - Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation after servicing/installation. For replacement parts and other information, refer to the Owner's Manual for servicing phone numbers. NOTE: If the dryer has been exposed to temperatures below freezing for an extended period of time, allow it to warm up before pressing POWER. Otherwise, the display will not come on. The dryer is now ready for use. 31