GE SCA1000HWW Owners Manual - Page 40
Optional kits, first, disconnect power at the main fuse., WB2X9883, Filler Panel Kits, Filter Kits
UPC - 084691083573
View all GE SCA1000HWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Charcoal filter (JX81A) To remove the charcoal filter To install the charcoal filter Optional kits 40 Care and Cleaning www.geadvantium.com The charcoal filter cannot be cleaned. It must be replaced. Order Part No. WB2X9883 from your GE supplier. If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors. The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6 to 12 months, depending on usage). To remove the charcoal filter, first disconnect power at the main fuse. Remove the top grille by removing the 2 screws that hold it in place. You may need to open the cabinet doors to remove the screws. Slide the filter towards the front of the oven and remove it. Remove 2 grille screws to remove the grille. To install a new filter, remove plastic and other outer wrapping from the new filter. Insert the filter into the top opening of the oven as shown maneuvering it behind the plastic grille until it fits squarely into place. It will rest at an angle behind the plastic grille on two side support tabs and in front of the right rear tab. Replace the grille and 2 screws. Reconnect power at the main fuse. Available at extra cost from your GE supplier. Filler Panel Kits Filter Kits ■ JX40WH-White ■ JX41-Black When replacing a 36″ range hood, filler panel kits fill in the additional width to provide a custom built-in appearance. For installation between cabinets only; not for end-of-cabinet installation. Each kit contains two 3″ wide filler panels. ■ JX81A-Recirculating Charcoal Filter Kit Filter kits are JX81A used when the oven cannot be vented to the outside. See back cover to order by phone or at ge.com. JX40, JX41