GE WSM2420DWW Use and Care Manual - Page 14
How To Operate Your Dryer - general
UPC - 084691096337
View all GE WSM2420DWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
HOW TO OPERATE YOUR DRYER WARNING-To reduce the risk of fire, electric shock, or injury to persons when using your appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Regular LIGHT SOIL - 8 NORMAL - 10 HEAVY - 12 MIN PULL KNOB TO START PUSH TO STOP = RINSE = SPIN OFF 10 MIN 6 Permanent Press COOL DOWN RINSE OFF 6 MIN 4 Delicates COLD COLD WARM COLD MED HOT SMALL COLD LARGE *= ENERGY PREFERRED AUTOMATIC SETTING PUSH TO START DRYER WASH RINSE Temp Load Size Spacemaker Laundry Start Auto - LESS DRY Regular NORMAL* MORE DRY OFF 10 MIN Air 20 Fluff OFF OFF MORE DRY * NORMAL Auto- LESS DRY Perm Press COOL DOWN OFF 50 MIN NORMAL 40 30 10 20 DE-WRINKLE Timed See How to Operate Your Washer section for the above Washer controls. Check the Lint Filter Clean the lint filter each time the dryer is used. Always be sure the lint filter is in place. WARNING-Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating, damage fabrics and be a fire hazard. The lint screen is located inside the dryer drum, on the back wall. To clean: 1. Use the finger holes to pull the lint screen straight out. 2. Lightly squeeze the body, PULL STRAIGHT OUT as shown while pulling the cover off. 2 3. ROLL lint off the screen with your fingers. Do not rinse or wash the screen. 4. Replace the cover on the body of the lint screen. 5. Before replacing the lint screen, remove any lint from the wire mesh on the back wall (behind the lint screen). 6. Push the lint screen straight back until it snaps into place. 1 SQUEEZE BODY; PULL COVER OFF Sort and Load the Clothes Good sorting for the dryer begins at the washer. Generally, if clothes are sorted right for washing, they're sorted right for drying. See the How to Sort Clothes section. If you do mix various types of fabrics in your load, set the controls for the lighter-weight fabrics and remove when dry. Reset controls for the remaining heavier fabrics. Set the Controls See the Suggested Fabric and Drying Selections guide. 1 Cycle Selector. Turn the Cycle Selector to the desired cycle setting. The selector may be turned in either direction. 2 Start Button. Press the Start button to start the dryer. (Opening the door during operation stops the dryer. To restart, close the door and press the Start button.) NOTE: Drying times will vary according to the type of heat used (electric, natural gas or LP gas), size of load, types of fabrics, wetness of clothes and condition of exhaust ducts. 14