Gigabyte B450 AORUS Elite V2 User Manual - Page 16

S B_ _B S S_ _ B DEBUG PORST DEBSUG PORT _S _U S__ _B B F_USB3 F _U _ B F_USB3 F _ _ 9/10) ASATA3 0/1, SATA 3 0/1/2/3 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/sF standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA connectors support RAID 0, RAID 1, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring a RAID array. 1 0 ASATA3 1 7 2 SATA3 3 7 7 F G_.0QBOFM 1 SATA3 0 1 1 7 1 _01 7 _F Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND DEBUG PORT DEBUG PORT _F _0 F 11) M2A_SOCKET/M2B_SOCKET (M.2 Socket 3 Connectors) The M.2 connectors support M.2 SATA SSDs or M.2 PCIe SSDs (Note) and support RAID configuration. Please note that an M.2 PCIe SSD cannot be used to create a RAID set either with an M.2 SATA SSD or a SATA hard drive. To create a RAID array with an M.2 PCIe SSD, you must set up the configuration in UEFI BIOS mode. Refer to Chapter 3, "Configuring_ a0 RAIFD Set," for instructions on configuring a RAID array. M2A_SOCKET 110 80 60 42 M2B_SOCKET (Note) F_USB30 3 F_USB30 3 80 60 42 Follow the steps below to correctly instal_l3an M.2USSD in the M.2 connector. Step 1: Get a screw and a standoff from the included M.2 screw and standoff packs. Locate the M.2 connector where you will install the M.2 SSD, use a screwdriver to unfasten the screw on the heatsink and then remove the heatsink. Step 2: _3 U Locate the proper mounting hole for the M.2 SSD to be installed and then tighten the standoff first. Insert the M.2 SSD into the M.2 connector at an angle. Step 3: Press the M.2 SSD down and then secure it with the screw. Replace the heatsink and secure it to the original hole. Select the proper hole for the M.2 SSD to be installed and refasten the screw and nut. G.QBOFM G.QBOFM (Note) The M2B_SOCKET connector supports only PCIe SSDs. - 16 -