Gigabyte GA-790FXTA-UD5 Manual - Page 51
Onboard ESATA Mode JMicron JMB362 Chip, eSATA Connectors on the Back Panel, JMicron JMB362 Chip
UPC - 818313009289
View all Gigabyte GA-790FXTA-UD5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
OnChip SATA Port4/5 Type (AMD SB750, SATA2_4~SATA2_5 connectors) This option is configurable only when OnChip SATA Type is set to RAID or AHCI. Configures the operating mode of the integrated SATA2_4/SATA2_5 connectors. IDE Disables RAID for the SATA controller and configures the SATA controller to PATA mode. (Default) As SATA Type The mode depends on the OnChip SATA Type settings. Onboard ESATA controller (JMicron JMB362 Chip, eSATA Connectors on the Back Panel) Enables or disables the SATA controller integrated in the JMicron JMB362 chip. (Default: Enabled) Onboard ESATA Mode (JMicron JMB362 Chip, eSATA Connectors on the Back Panel) Enables or disables RAID for the SATA controller integrated in the JMicron JMB362 chip or configures the SATA controller to AHCI mode. IDE Disables RAID for the SATA controller and configures the SATA controller to IDE mode. AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. (Default) RAID Enables RAID for the SATA controller. Onboard SATA3 controller (Marvell 9128 Chip, GSATA3_6/7 Connectors) Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled) Onboard SATA3 Mode (Marvell 9128 Chip, GSATA3_6/7 Connectors) Allows you to decide whether to configure the SATA controller integrated in the Marvell 9128 chip to AHCI mode. IDE Configures the SATA controller to IDE mode. (Default) AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. GSATA RAID Configuration (Marvell 9128 Chip, GSATA3_6/7 Connectors) Allows you to configure RAID for the Marvell 9128 SATA controller. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Onboard LAN device CMOS Setup Utility-Copyright (C) 1984-2009 Award Software Onboard LAN device Onboard LAN1 Function Onboard LAN1 Boot ROM } SMART LAN1 Onboard LAN2 Function Onboard LAN2 Boot ROM } SMART LAN2 [Enabled] [Disabled] [Press Enter] [Enabled] [Disabled] [Press Enter] Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Onboard LAN1/LAN2 Function Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. - 51 - BIOS Setup