Gigabyte GA-7PCSL Manual - Page 28
SATA0/1 SATA 6Gb/s Connectors
View all Gigabyte GA-7PCSL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
11) SATA0/1 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s standard. Each SATA connector supports a single SATA device. GA-7PCSL Pin No. Definition 7 1 GND 2 TXP 3 TXN 4 GND 5 RXN 1 6 RXP 7 P5V/GND GA-7PCSLX • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 3Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. - 28 - Hardware Installation
- 28 -
Hardware Installation
GA-7PCSL
GA-7PCSLX
11) SATA0/1 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s standard.
Each SATA connector supports a single SATA device.
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
P5V/GND
•
A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are configured, the total number of hard drives must be an even number.
•
A RAID 10 configuration requires four hard drives.
7
1
(Note)
When a RAID configuration is built across the SATA 3Gb/s channels, the system performance of
the RAID configuration may vary depends on the devices are connected.