Gigabyte GA-7PTSH Manual - Page 19
SATA0/SATA1 SATA 6Gb/s Connectors, SATA2/SATA3/SATA4/SATA5 SATA 3Gb/s Connectors, RAID_KEY1 RAID
View all Gigabyte GA-7PTSH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
3) SATA0/SATA1 (SATA 6Gb/s Connectors) SATA2/SATA3/SATA4/SATA5 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. 7 1 SATA4SATA2SATA0 SATA5SATA3SATA1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. 2x9 pin 4) RAID_KEY1 (RAID Selection Connector/Opional) 1 3 Pin No. 1 2 3 Definition GND SSB_SAS/SATA_RAID_KEY GND - 19 - Hardware Installation