Gigabyte GA-8N-SLI Royal Manual - Page 13
After the SATA controller driver installation is completed, you should see a screen similar to
View all Gigabyte GA-8N-SLI Royal manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Step 4: When the next screen (Figure 18) appears, press ENTER to continue the SATA driver installation from the floppy disk. Windows Setup Setup will load support for the following mass storage device(s): NVIDIA RAID CLASS DRIVER (required) NVIDIA nForce Storage Controller (required) * To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows, including those for which you have a device support disk from a mass storage device manufacturer, press S. * If you do not have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for use with Windows, press ENTER. S=Specify Additional Device Enter=Continue F3=Exit Figure 18 After the SATA controller driver installation is completed, you should see a screen similar to that below. You can proceed with the Windows 2000/XP installation now. WindowsXP Professional Setup The following list shows the existing partitions and unpartitioned space on this computer. Use the UP and DOWN ARROW keys to select an item in the list. l To set up Windows XP on the seleted item, press ENTER. l To create a partition in the unpartitioned space, press C. l To delete the selected partition, press D. 114471 MB Disk 0 at Id 0 on bus 0 on nvraid (MBR) Unpartitioned space 114471MB ENTER= Install C=Create Partition F3=Quit Figure 19 - 13 - SATA Hard Drive Configurations (nForce series)