Gigabyte GA-8N-SLI Royal Manual - Page 8

Ác After that, the Array List screen displaying the RAID array you created will appear (Figure 9). Åé If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array and press B. The Boot section will show Yes. ¤¤ NVIDIA RAID Utility Nov 5 2004 - Array List - ¤å Boot Id Status Vendor Array Model Name No 2 Healthy NVIDIA STRIPE 111.79G [Ctrl-X] Exit [h i ] Select [B] Set Boot [N] New Array [ENTER] Detail Figure 9 To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure 10), where you should see detailed information about RAID mode, disk block size, disk model name, and disk capacity, etc. RAID Mode: Striping Striping Width : 1 Array 2 : NVIDIA MIRROR 111.79G - Array Detail - Striping Block: 64K Adapt 1 1 Channel M/S 0 Master 1 Master Index 0 1 Disk Model Name ST3120026AS ST3120026AS Capacity 111.79GB 111.79GB [R] Rebuild [D] Delete [C] Clear Disk [ENTER] Return Figure 10 To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears, press Y to confirm or N to cancel. Press ENTER to return to the Array List screen. To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen. Now, you can proceed to install the SATA controller driver and operating system. SATA Hard Drive Configurations (nForce series) - 8 -